Purchasing Energy

The condenser heat exchangers are light enough that no crane is required for replacement. And when it’s time to clean them, city tap water, with water pressure typical of a spray from a common garden hose, is all that’s needed. The QTC3 chiller comes standard with native communication capability for BACnet (MS/ TP), Modbus, and N2, with optional capabilities available for LON. The standard unit capabilities include built-in-scheduling, remote start-stop, remote water temperature reset and up to two steps of demand limiting depending on model.

A thermal effectiveness of up to 0.91 was obtained in using the water mist system. The pre-cooled condenser air enabled a drop of the condensing temperature by up to 7.2 K, and the chiller coefficient of performance could be improved in varying degrees by up to 18.6%. Traditionally, Air-cooled chillers operate in a closed loop cooling application where all of the water pumped from the chiller returns to the main unit under the pressure generated by the pump. Air cooled chillers absorb heat from process water, and the heat is then transferred to the air around the chiller unit.

Our air-cooled chillers are durable, have user-friendly features, and are designed to remain quiet over its entire operating range. Our ThermoFlex™ Recirculating Chiller is configurable and have a cooling capacity up to 24,000 watts (81,948 btu/hr). Contact us today and a representative will find a chiller that’s right for you. IQS Directory is a top industrial directory listing of leading industrial air cooled chiller manufacturers and suppliers.

air-cooled chillers

We have in stock for immediate shipment our most popular cased and uncased coil products. The production and importation of R-22 ended as of January 1, 2020 but the use of existing inventories and reclaimed refrigerant is still allowed. Learn more about the US Department of Energy’s new regulations on energy reductions for commercial walk-in coolers and freezers, and how they may impact your business. MarketandResearch.biz is a leading global Market Research agency providing expert research solutions, trusted by the best. We understand the importance of knowing what global consumers watch and buy, further using the same to document our distinguished research reports. We study consumers in more than 100 countries to give you the most complete view of trends and habits worldwide.

In addition, Ohio CAT will engineer your system to deliver the performance you need and to comply with safety and code requirements. The noise of air cooled chillers cannot be determined as each fans installed in them would have a different decibel. Although, there are various ways to decrease the noise produced by them, it is always better to invest in a system, which is quieter.

It is dual compressor, and Cold Shot’s special LT model for breweries/wineries, so this 10 hp chiller will chill your glycol fluid down to the desired 25°F range. Unit is 208/230 volt, 3 phase, and uses the new R410a refrigerant. Arrived at KIG in January 2016 were these three immaculate Donaldson 10 ton Air Cooled Chillers.

Using our robust custom-capable lineup of comfort cooling chillers, our advanced engineering team can incorporate even more options for optimal performance and control. The Air Conditioning, Heating, and Refrigeration Institute conducted several studies to identify the true amount of time a chiller runs at full vs. partial load. If you assume a 2 shift operation, 5 days a week for one year, the energy savings for a 10 ton chiller are $4,690 or 58% less than a chiller with a fixed speed compressor. These energy cost savings can pay for a chiller in less than 3 years. We set the cooling tower design output temp to 44F, which is the output of the regular chillers.

Leave a Reply

Your email address will not be published. Required fields are marked *